|
|
Moose Racing Z50 Rear Hub Bearing & Seal Kit
|
2 in stock
Item Number: PUA25-1167
Manufacturer: Moose Racing
- Bearing seals are double-lipped rubber that provides superior exclusion of water, dirt and sand with improved grease retention
- Steel garter spring guarantees constant pressure on the axle shaft, extending the life of the seal
- Wheel seals are type TC nitrile elastomer, specifically designed to keep out water, dirt and sand
- Seals have a rubber-coated outside diameter that creates an optimum seal at the hub
- High-speed, low-drag bearings are EMQ quality
- Kits include all required bearings and seals
- This is a kit that will fit all the below models, so you may or may not use all parts in the kit for you application.
Inspection: Check to make sure that all mating surfaces are clean and free of burrs and corrosion. Check all mating surfaces for wear and replace as necessary.
Wheels: Inner spacer edges must be square to seat properly against new bearings. If worn, replace. Outer wheel spacers should be inspected for wear from the external seal lip Replace as required.
Installation: Bearings should be mounted slowly with care, by using a fixture to apply force evenly to the bearing. When mounting the inner ring, apply force to the inner ring only. Similarly, when mounting the outer ring, apply force to the outer ring only, Bearings need to be kept square to the mating surface to avoid damage.
Suspension: Needle bearings should be installed with a press and installation tool to apply force evenly to the bearing.
Steering: Install the bottom bearing with a pipe tool that applies pressure evenly. Tip: Heating mating components will make installation easier due to the expansion of the part Grease all seal surfaces where they contact metal parts. Grease needle bearings thoroughly after installation.
Wheel Bearing Kit Honda CRF50F 04-07, XR50R 00-03, Z-50 70-78, Z-50R 79-93
| 1979-1993
|
Honda
|
Z50R
|
-
|
-
|
| 2004-2020
|
Honda
|
CRF50F
|
-
|
-
|
| 1969-1978
|
Honda
|
Z50
|
-
|
-
|
| 2000-2003
|
Honda
|
XR50R
|
-
|
-
|
| 1986
|
Honda
|
Z50RD
|
|
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
|
MSRP: $18.59
Price: $13.31
You Save: $5.28 (28 %)
Theses are replacement brake shoes for the classic CT70, 1971+ Z50's and reproduction bikes. The brake shoes are made from high quality material for long use.
-This Part Will Fit-
All CT70s
All Replicas
|
JT Black 420 37th Tooth rear sprocket. Stock size for most Z50s. It is highly recommended to change the front sprocket, rear sprocket and chain all at the same time!
|
Front or rear axle castle nut
|
Genuine Honda 12mm self-locking axle nut (#20 in diagram). Fits CT70 (1970 K0–1971 HKO), Z50 (1969–1978), and other Honda models. Replaces standard 12mm nut—no cotter pin needed.
|
Honda Stock Rear Sprocket Retention Plate for the Z50A model.
Will fit on years: 1969-1974; K0-K5 models. It will also work on a QA50 1971-1975 (K0-K3).
It is #24 in the schematic.
| |
Product Reviews
|
|