|
Cables
Throttle Cable Grommet that mounts on the inside of the handlebars. It is #2 in the diagram. Will fit:
CT70 1970-1974; Z50A 1969-1978; CT90 1966, 1969-1972, 1974. Will also fit other Honda models.
|
Clone Clutch Cable for the YX140cc motor. Mounts into the YX140 (TB278) & will work w/ our controller (TB026LH). It will be too short if you use any of the other perches that we have on our website.
Housing sheath is 46 in ;Inner cable length is 49 1/4in
|
Z50A front brake cable for Z50AK1/K2 (1970-71) models. It measures at an overall length of 37". The internal switch mechanism is faulty. This is a non returnable/non refundable item. Sold as is.
|
Trailbuddy has reproduced the 1969-1971 CT70 Throttle Cable with Grey Sheathing. The overall length is 34.5 inches and the sheathed cable length is 30.75". Will fit: CT70 1969-1971, 1969-1971 Z50 but will be a bit long.
|
Includes a rubber cap, two locknuts, cable adjuster and elbow tube. Replaces often damaged or missing cable adjusting elbows on Keihn and Mikuni carbs.
|
Special blend of Red Line® synthetic lubricants and rust inhibitors keeps your cables working smoothly in any weather condition from hot to cold, wet or dry
|
Clamps over housing and wire allowing an aerosol can to be connected. Once lube runs out the far end, the cable is lubricated. Used to inject lubricant into cable housing. Works great with Motion Pro Cable Oil.
|
Clone Clutch Cable 41.25" long
Works with the TB026LH controller to either the TB526 Lifan 125cc Manual or the CT70 H Motor
|
2in Longer Clone Throttle Cable twist in style.
Replacement throttle cable for the replicas bikes.
31" sheath and 35"cable length
This will only work with our TB026RC and/or TB026RCBL controllers and best with our Tall bars (TB197).
|
Outer Throttle Cable Holder for stock Honda setup. Will fit: CT70 1969-1974; and Z50A 1969-1978. It is #18 in the diagram.
This is a Right hand thread.
| | |
|
|