·
Bearing
seals are double-lipped rubber that provides superior exclusion of water, dirt
and sand with improved grease retention
·
Steel
garter spring guarantees constant pressure on the axle shaft, extending the
life of the seal
·
Wheel
seals are type TC nitrile elastomer, specifically designed to keep out water,
dirt and sand
·
Seals
have a rubber-coated outside diameter that creates an optimum seal at the hub
·
High-speed,
low-drag bearings are EMQ quality
·
Kits
include all required bearings and seals
·
This
is a kit that will fit all the below models, so you may or may not use all
parts in the kit for you application.
Inspection: Check to make sure that all mating surfaces are clean and free of burrs and corrosion. Check all mating surfaces for wear and replace as necessary.
Wheels: Inner spacer edges must be square to seat properly against new bearings. If worn, replace. Outer wheel spacers should be inspected for wear from the external seal lip Replace as required.
Installation: Bearings should be mounted slowly with care, by using a fixture to apply force evenly to the bearing. When mounting the inner ring, apply force to the inner ring only. Similarly, when mounting the outer ring, apply force to the outer ring only, Bearings need to be kept square to the mating surface to avoid damage.
Suspension: Needle bearings should be installed with a press and installation tool to apply force evenly to the bearing.
Steering: Install the bottom bearing with a pipe tool that applies pressure evenly. Tip: Heating mating components will make installation easier due to the expansion of the part Grease all seal surfaces where they contact metal parts. Grease needle bearings thoroughly after installation.
Wheel Bearing Kit Front Honda Z-50 68-78, Z-50R 79-99, Z-50RD 86, Suzuki NMUU 30-01, NMUS 02 20, KMUSL U3 18, Wheel Beaning Kit Hear Honda 50R 94-99
| 1986
|
Honda
|
Z50RD
|
-
|
-
|
| 1979-1999
|
Honda
|
Z50R
|
-
|
-
|
| 1969-1978
|
Honda
|
Z50
|